Programming
INS 034-9
37
The Zone Soak Test Suite defines the zones that are on Soak Test. To program
the Zone Soak Test Suite,
enter
%(
.
The zone lights of the zones currently
included in the Zone Soak Test Suite will illuminate.
Press the appropriate
numbered button(s) of the zone(s) to be included or excluded. Press
,
.
The system will chime to confirm that the new Zone Soak Test Suite has been
accepted. The system will then automatically revert to the Programming Menu and
all the zone lights will illuminate.
1)
Soak Test is not appropriate for Entry/Exit, Push to Set, or Keyswitch Zone
Types and these zones will still be monitored as normal even if they are
included in the Soak Test Suite.
2)
Zones which fail Soak Test will be automatically added to the Manual Omit
Suite (section 3.15.4, page 36) which should be checked after a Soak Test
failure.
3)
When the Soak Test Suite is programmed the Soak Test Time is started
therefore this should be programmed first (section 3.13, page 33).
4)
Zones that have failed Soak Test will be cleared when the Soak Test Suite is
programmed.
If a Soak Test zone activates all subsequent zone activations will be logged as
well. For example, zones 5, 6, 7 & 8 are on Soak Test. Zones 7 & 8 activate and
are logged (zone light On). The user then returns via Zone 1, Zone 2 & Zone 3.
These zones will all be logged as well but while Zone 2 & 3 lights will be On, Zone
1 light will be Flashing as this was the first non Soak Test zone to be activated.
3.16
Changing the Engineer Code
'!
The User Code will also allow access to the Programming Menu but 24 Hour
zones are not disabled and options are restricted to Testing the Bell, Strobe &
Speaker, Walk Testing and Viewing the Log.
The following procedure changes the code which was used to access the
Programming Menu:
1)
If the Programming Menu was accessed with the Engineer Code then the
Engineer Code will be changed.
2)
If the Programming Menu was accessed with the User Code then the User
Code will be changed.
From the Programming Menu:
1) Enter 60 to select the Change Code option
'!
2) Enter the new 4 digit Code
++++
3) Press PROG to program the new Code
,
The system will chime & revert to the Programming Menu
The factory set Engineer Code is
"#$%
.
