Texecom Veritas 8, Руководство по установке

Страница: 34 / 44

Programming
34 INS 034-9
The system will automatically revert to the Programming Menu and all the zone
lights will illuminate.
1) The Bell Cut Off Time
&
is the length of time for which the bell sounds.
2) The Part Set Error Tone Suspension Time
'
would typically be used to
suspend the error tone (indicating an open zone) to avoid disturbance when
there are detectors on the part set exit route.
3) The Zone Soak Test Time
(
is used in conjunction with the Zone Soak Test
Suite (section 3.15.6, page 36).
4) Some bell boxes have a built in timer. In this case the bell will sound for
either its built in time or the programmed cut-off time, whichever is the
shorter.
3.14 The Seven Event Basic Log
The control panel has a Seven Event Basic Log which stores the last 7 alarm
activations. The zone light of the zone which first caused the alarm activation will
flash, and the zone lights of any subsequently opened zones will illuminate.
3.14.1 Clearing the Seven Event Basic Log %!
From the Programming Menu,
enter %! .
All the zone lights will turn off.
Press
, .
The system will chime to confirm that the Seven Event Basic Log has
been erased. The system will then automatically revert to the Programming Menu
and all the zone lights will illuminate.
3.14.2 Displaying the Seven Event Basic Log
%+
From the Programming Menu, press
%
followed by the number corresponding
to the desired event ,
"
being most recent,
)
being least recent (e.g. to recall
the second most recent event, enter
%#
). The zone light of the zone which first
caused the alarm activation will flash, and the zone lights of all subsequently
opened zones (if any), will illuminate.
If the Tamper light is on or flashing, an extended display reveals more information
about the source of the tamper alarm(s). To toggle between the normal display
and the extended display,
press
.
. The extended display is distinguished from
the normal display by the Unset light being off. In the extended display the zone
lights are interpreted as follows:
Zone Light Description
1 Bell Tamper (including Global System Tamper)
2 Power Supply Fault
3 Lid Tamper (including RKP Lid Tamper)
4 Not Applicable
5 RKP Off-Line
6 Code PIN Tamper
7 Keypad PA
8 Not Applicable
Press - . The system will return to the Programming Menu and all the zone
lights will illuminate.