INsTAllATION
29
© TESVOLT We reserve the right to make technical changes. Version RD.TI.015.E.ENG_Installation_Manual_TS48V_v.C.01 Last revised 06/2020
7
Cabinet extension for VX cabinet only:
First of all, on the front of
the cabinet, attach three baying connectors
L.1
to the central,
vertical cabinet profiles inside the cabinet at the top, middle and
bottom. The baying connectors are fastened to the frame profiles
with two M6 x 35 setscrews
L.3
on each side from the right and
left. For now, only tighten the screws loosely.
8
Cabinet extension for VX cabinet only:
Now, fit the remaining
three baying connectors
L.1
to the vertical cabinet profiles at the
rear of the cabinet at the same height as the front baying connec-
tors already installed. When fitting the bottom baying connector,
use the same process as for fitting on the front cabinet profiles.
For the middle and top baying connectors, the slide rail must first
be removed from one side of the fitting area.
9
Cabinet extension for VX cabinet only:
Now fasten the middle
and the top baying connectors using their four front holes using
four ST5.5 x 13 pan head screws
L.2
. Then refit the relevant
slide rail.
10
Cabinet extension for TS/VX cabinet only – optional:
The sealing strip
M.5
can be fitted between the cabinet frame
abutting faces. The sealing strip has a self-adhesive side; use this
to fasten it to one of the cabinets’ abutting faces (frame profiles).
The sealing strip is purely aesthetic and does not have a func-
tional purpose.
11
Cabinet extension for TS/VX cabinet only:
Now attach the lower
baying connectors
M.1
in the cabinet. The lower baying connec-
tor is attached to the two abutting horizontal cabinet frame pro-
files on the two halves of the cabinet. To do this, place a speed
nut
M.4
underneath each of the corner holes of the baying con-
nector from the cabinet frame profile side. Use an M8 x 16 pan
head screw
M.3
to fasten the connector.
12
Fit the last upper baying connector
M.1
in the center of the cabinet where the abutting cabinet frame
profiles of the two halves of the cabinet meet. Repeat the above step.
