INsTAllATION
25
© TESVOLT We reserve the right to make technical changes. Version RD.TI.015.E.ENG_Installation_Manual_TS48V_v.C.01 Last revised 06/2020
6 INSTALLATION
6.1 SETTING UP THE CABINET
1
Remove the packaging and transport locks from the cabinet.
2
Optional – Installing crane lugs:
When transporting the empty cabinet by crane, install four crane
lugs at the four corners of the cabinet. To do this, remove all the
fastening screws from the cabinet cover and replace them with
the crane lugs
G
.
3
Transport the empty cabinet to its final installation site. While doing so, ensure that you follow the
safety information in the section “3.3 Transport at the end customer’s site” on page 11.
4
Optional – Lifting the cabinet covers for additional ventilation:
First of all, remove all crane lugs or fixing screws and the upper
cabinet cover (TS cabinet variant shown in picture as example)
5
Optional – Lifting the cabinet covers for additional ventilation:
Now screw the four spacers
H
into the threaded holes at each
corner of the cabinet frame.
6
Optional – Lifting the cabinet covers for additional ventilation:
Then place the top cabinet cover on the spacers and fasten it with
four M6 x 16 countersunk screws (TX 25)
H.1
including plastic
washers
H.3
.
Next fasten the cover caps
H.2
to the plastic washers.
7
Now attach the type plates
6
to the cabinet in the following positions: 1 x on the inside of the door
and 1 x visible on one external side wall.
