TERRY Melody 1, Руководство по установке

Страница: 5 / 66

Terry Melody 1 - Installation Instructions - ED01050g
5
ref: ED01052c, dated: 10/01/2012
9. Connect the 8 core cable from charger and cable from lower wall station
as per diagram below.
Note: Ensure anti-creep (purple wire to mech wheel) is disconnected.
Wire must only be reconnected after all height settings are complete.
10. Secure wiring in place with tie wraps.
11. Connect up hydraulic hose to pump.
12. Remove 8 sets of barrel nuts/dome head screws /washers /lockwashers
from platform uprights (4 off).
13. Gate & lock fitting;
• Take note of the gate handing on the lift
paperwork. The handing refers to the side of
the gate hinge when viewing the lift from the
lower level. The diagram shows a left hand
gate.
• Fit the gate by sliding the required handrail
through the hinge tubes on the gate and
positioning the gate handrail in place along with appropriate kick plate
and refit both sets of barrel bolts/nuts.
• Lift the gate upwards to reveal the holes in the
handrail.
• Fit the gate hinge pin, spacer tube, 2 circlips
and domed star washer in the order shown.
Ensure pin is inserted in the correct hole! As the
gate is opened it will rise if the correct hole has
been used.
NOTES
8 core for charger
Power Pack wiring
Carriage Gate
Lower Call Station