Tennant M17 Series, Руководство по эксплуатации

Страница: 50 / 236

3-2 0
MAINTENANCE
CLEANING THE HOPPER DUST FILTER
Use one of the following methods to clean the
dust f i lter:
SHAKING-Press the f lter shaker switch .
TAPPING-Tap the f i lter gently on a f l at surface. Do
not damage the edges of the f i lter. The f i lter will
not seal properly if the edges of the f i lter are
damaged.
AIR-Always wear eye protection when using
compressed air. Blow air through the center of the
f i lter and out toward the exterior. Never use more
than 550 kPa (80 psi) of air pressure with a nozzle
no smaller than 3 mm (0.13 in) and never hold the
nozzle closer than 50 mm (2 in) to the f i lter.
THERMO-SENTRY
The Thermo-Sentry, located inside the
hopper, senses the temperature of the air pulled
up from the hopper. If there is a f i re in the hopper,
the Thermo-Sentry stops the vacuum fan and
cuts off the air f l ow. The Thermo-Sentry
automatically resets after cooling down.
INSPECTING / CLEANING THE PERMA-FILTER
Inspect and clean the Perma-Filter after every 100
hours of operation.
M17 Service Information 90 17358 (0 8 -2016)