Snappi Seat Standalone Workshop Manual
Document No: 053-08 v2
Page 36 of 49
March 2019
Snappi Seat Standalone Workshop Manual.doc
Tuck the lower end of the back cover around
the bottom of the backrest and behind the
backrest plate as shown (see Fig 8.26,
right).
Fig 8.26
Fig 8.27
Next fit the extended side wing covers by
sliding over the plastic boards. Fold the
extended tabs on the inside of the side wing
cover around the plastic board and tuck
under the outside of the cover- then clip the
poppers together.
Position the 1” seat pad into the middle of
the seat base, with the front edge of the pad
lined up with the front edge of the seat place.
Secure down onto the loop strip on the base
plate as shown (see Fig 8.28, right).
Fig 8.28
Fig 8.29
Fit the original seat cover over the seat pad,
tucking the excess cover in the gap between
the seat base and backrest as shown in fig
8.29, left.
