Snappi Seat Standalone Workshop Manual
Document No: 053-08 v2
Page 47 of 49
March 2019
Snappi Seat Standalone Workshop Manual.doc
Fig 9.12
Fit the original seat base cover into the seat-
it will attach to the hook strip on the base of
the seat. The excess seat cover tucks into
the gap between the seat base and back
rest (see Fig 9.12, left).
Note: The following instructions are only
applicable if the seat being converted
includes either lateral trunk supports or
lateral head wings.
Place the two M8 x 25 coach bolts through
the slots in the lateral / head wing bracket.
Slide the bracket through the slot in the
cover so that it sits against the backrest with
the coach bolts protruding through the
corresponding vertical slot in the back rest.
Place an M8 washer on each coach bolt on
the back of the seat as shown (see Fig 9.13,
right).
Fig 9.13
