Snappi Seat Standalone Workshop Manual
Document No: 053-08 v2
Page 24 of 49
March 2019
Snappi Seat Standalone Workshop Manual.doc
7.6: Removing and Fitting Snappi Playtray receiver Brackets
Snappi playtray receiver brackets are supplied as standard on all Snappi pushchairs. The
below instructions advise, if necessary, how you can remove and fit these brackets.
How to take off Snappi playtray receiver brackets
1. There are two silver bolts on the side (by the receiver brackets, see photo below),
take the back bolt off first using the 3mm Allen Key. Behind this bolt is a white
spacer. Take care not to lose this spacer. The spacer may be lodged in a little, if so,
you can get this out by turning the playtray bracket which will loosen the spacer.
2. To remove the front bolt, put the 8mm spanner on the nut which is on the inside of
the bracket (see photo below) and unto the bolt with the Allen key. Underneath the
nut is a washer.
3. Repeat for the other side.
How to put on Snappi playtray receiver brackets
1. To refit the brackets, take the rear playtray bolt and put this through the back hole of
the receiver bracket, put the white spacer on the bolt. Screw this back into the frame
using the 3mm Allen key
2. Take the front bolt and wiggle it through the front hole. Tighten using the 3mm Allen
key.
3. Put your washer and nut back on the end of the bolt and tighten using the 8mm
spanner.
4. Tighten both the front and rear bolts with the Allen key until the playtray bracket
doesn’t wobble.
5. Repeat for the other side.
