Snappi Seat Standalone Workshop Manual
Document No: 053-08 v2
Page 18 of 49
March 2019
Snappi Seat Standalone Workshop Manual.doc
Fig 7.4.2.1
Place the footrest slide assembly onto a flat
surface.
Using a 5mm drill bit drill off the 6 rivets that
secure the plastic tray to the metal base
plate.
Position the new foot tray onto the base
plate, so that the cut-out slots in the tray line
up with the holes in the plate. Using a 5mm
drill and the base plate as a template, drill off
the 6 mounting holes in the new foot tray.
Fig 7.4.2.2
Fig 7.4.2.3
Secure the new tray onto the base plate
using 6 x black 4.8 mm rivets (supplied).
Finally, re-attach the foot tray assembly onto the footrest stems, and secure with the 2 x
self-tapping screws.
7.4.3: Footrest Slide Assembly:
The footrest slide assembly will come pre-assembled complete with the plastic tray. To fit
the new assembly, simply remove the old slide assembly following the instructions given in
section 7.4.1 above. Slide the new assembly in place and secure back in place.
