Snappi Seat Standalone Workshop Manual
Document No: 053-08 v2
Page 22 of 49
March 2019
Snappi Seat Standalone Workshop Manual.doc
Take the frame fixing bracket and fit onto the
end of the bolt as shown (see Fig 7.5.10,
right). Note the brackets are handed and will
only fit one way around. Make sure the
correct hand is used so that the large teeth
on the bracket and plastic adjustor line up.
Fig 7.5.10
Fig 7.5.11
Take the ‘small teeth’ adjustor and fit over
the end of the bolt. Thread the rear bar over
the bolt so that it sits into the recess in the
small teeth adjustor, and then secure with
the thumb screw as shown (see Fig 7.5.11,
left).
Finally, take the small elastic loop on the end
of the cover, and hook over the thumbscrew
as shown (see Fig 7.5.12, right).
Fig 7.5.12
