TellSystem Communication ProCon GSM, Инструкция по установке и эксплуатации

Страница: 14 / 23

ProCon GSM
•
During voice recording it records from the default microphone. Sometimes it needs to be adjusted (ex. amplify) for
the optimal volume and quality.
•
By clicking the Play button you can listen to your recording.
•
If you would like to upload a prerecorded sound file than you can open a file upload window by clicking the
appropriate event button.
•
The file format has to be compatible with the format used on GSM networks. It has to be 8 kHz sampling rate, 8
bit, mono PCM modulated ’’.wav’’ file.
When you have the desired sound it can be uploaded to the module by clicking the Upload button.
Adjusting outputs
On the Output window the output settings can be changed. The output type
can be monostable namely one statused, (switches for the given period
than reverts back to the original status), or bistable namely two statused (it
only will revert back to original state after a new controlling).
•
Regarding monostable operation switch time can be set in seconds
or minutes. This can be max 65,000 seconds.
•
The Unsuccessful SMS means output will be controlled when
network operator rejects an SMS sending.
•
Choosing GSM fault output will be controlled as long as GSM
network reverts to its normal state
•
Regarding output controlling it can be set if you want to control with
incoming call or it should be activated by an alarm event (ex. in
case of 24/7 active input).
•
When controlling with caller identification is set you can choose between unidentified or identified phone number
controlling.
•
Anybody can control the output with unidentified phone number controlling if he/she knows the phone number of
the SIM card.
•
If the phone number identification is selected controlling from a controlling phone number not in the list
will be denied. This greatly improves module safety regarding unauthorized controlling.p. 21.
•
EXP Relay provides additional 1, EXP Relay3 provides 3 additional
outputs for the GSM module. Thus by using EXP Relay 3 the module
can have 4 outputs.
•
Only one expansion panel can be connected simultaneously. Expansion
panels connect to the Panel labeled slot of the modules.
•
Both expansions contain low-voltage relayed output switcher.
•
EXP Relay has NO/NC relay, EXP Relay3 has jumper adjustable output
for NO or NC version.
•
Output settings can be modified by sending the following message:
•
1234OUTx → Selectable parameters: ON, OFF, RUN or switch to a certain time (given in 5 characters)
•
example: 1234OUT1=00003 → controlling output 1 for 3 seconds
•
You can find more information on SMS commands on page 20. Figure 6: EXP Relay and EXP Relay3
Figure 6: Exp Relay and Exp Relay 3
Page 14
EXP RELAY
EXP RELAY3