TellSystem Communication ProCon GSM, Инструкция по установке и эксплуатации

Страница: 17 / 23

ProCon GSM
•
By using the expansion panel GSM module can be converted to standalone alarm center.
• The expansion panel connects to the slot next to the programmer port according to the position on figure 7.
• Simultaneously only one expansion panel can be attached to the module.
• The alarm center expansion module provides the following new features for the module:
• status output; if you connect an LED to it (using a resistor to control the flowing power) you can have light
feedback of the armed module status. When you arm the module the LED starts to flash.
• open collector output that serves as a second output. When it is controlled it will close with the GND of the
expansion alarm.
•
Extra input through which module can be armed/disarmed by a continuous contact or an impulse (we suggest
connecting key switch here)
• Piezzo connecting point; facilitating sound for differentiating exit time (arming state) and alarm
Remote surveillance settings (voice call)
•
Remote surveillance notification can be used side by side with the SMS and voice
call notifications. This feature works at more than 50% of signal strength.
•
Regarding the order first remote surveillance will be notified than remaining
notifications will be processed.
•
Two remote surveillance numbers can be set. If there is a connection failure with
the first number it will call the second phone number.
•
Client code is decided by the remote surveillance. You can use only your own
code.
•
The communication with the remote surveillance can be improved by changing the
signal level of the module transceiver.
•
First example: if remote surveillance cannot interpret the code received sender level has to be adjusted
•
Second example: if the GSM module during the
handshake does not receives accurately reply from
remote surveillance the Receiver value has to be
modified
•
Change the default settings only in case when this is
required by the available signal strength or by remote
surveillance distinctives.
Using your own signal (Contact ID) codes
•
The module can forward also self generated signals
(ex. signals to inputs, power supply failure) to remote
surveillance.
•
Contact ID and Zone codes can be modified.
•
Notification can be revised under the Maintenance -> Module state display tab. Here in the error code window
sending actual Contact ID is displayed.
•
If messages sent are not interpretable signal strength and module antenna position must be checked.
•
The connected antenna should be away from the module and any other electric device or cable!
GPRS settings
On this page the carrying protocol can be set for data transmission.
We suggest TCP usage only in justified situations, the UDP
communication facilitates much quicker communication.
•
In the latter case no need for user and password input.
•
Compatible communication protocols are ENIGMA and SIA
IP.
•
At server address IP address and Domain name (this
needs DNS server configuration) is also accepted.
Page 17