Telestream PRISM MPI2-10, Руководство пользователя

Страница: 35 / 302

Getting Started
SFP Module Installation
37
PRISM MPI2-10-MPX2-10 User Manual
SFP Module Installation
There are several types of optional SFP modules available:
•
"SD/HD/3G-SDI optical transmitter
•
"SD/HD/3G-SDI DIN transmitter
•
"SD/HD/3G-SDI HD-BNC transmitter
•
"10G Ethernet short range transceiver (850 nm)
•
"10G Ethernet long range transceiver (1310 nm)
Note:
ST2022-7 requires two 10GE SFP modules to be installed. The modules must be
installed in SFP ports 1 and 2.
MPX2-10 and MPI2-10 SFP Module Installation
To install an SFP module on an MPX2-10 or MPI2-10 monitor, insert the SFP module into
the SFP connector. The module latches into place when fully inserted.
Note: There are different types of SFP modules for 10GE signals. If the SFP module
does not match the unit signal setting (for example, a 25GE SFP module is installed),
the Link Status (in Network, under Settings) returns “SFP Error.”
To remove the SFP module, pull the latch down or up as according to the SFP and then
pull the module out of the SFP connector.
Note:
To ensure you are using the correct SFP connectors, the 10GE and SDI SFP
connectors are marked on the back of the MPI2-10 (see
MPI2-10 Rear Panel
Connectors
) and MPX2-10 (see
MPX2-10 Rear Panel Connectors
). Different types of SFP
modules may have different latching mechanisms.
SFP Module Transportation
Caution: To prevent static damage to the SFP module, if you remove the SFP
module from the instrument, always transport the SFP module in an anti-static
bag or container.
Caution: To prevent possible damage to the PRISM monitor and SFP modules,
remove the SFP modules before transporting the PRISM monitor.