Tailstock
!
Warning!
Never loosen the tailstock quill or
tailstock while the work piece is
turning.
1. To move the tailstock along the bed,
loosen the Tailstock Lock Arm, slide the
tailstock to the desired position, and tighten
the Lock Arm.
2. To move the tailstock quill in or out,
loosen the Quill Lock Knob and turn the
Handwheel. Lock the quill in place with the
Quill Lock Knob.
3. The tailstock quill accepts centers and
accessories with no. 2 Morse taper (#2
MT). To install a taper use a quick, firm
action by hand. Do not pound the taper in.
4. To remove a taper, insert the knock out
bar through the tailstock quill hole. While
holding the taper so it doesn’t fall, tap it
out.
5. The tailstock quill is hollow, allowing you
to bore holes through turnings if a hollow
center is used.
Adjusting the Tailstock for Turning Between Centers
1.
Mount the spur center to the work piece and insert the spur center into the headstock
spindle, as previously described under "Using a Spur Center".
!
Warning!
Do not use the tailstock quill action to drive the work piece into the
spur center. This can create an unsafe and loose work piece.
2.
Mount the live center into the tailstock quill using a quick, firm action by hand.
3.
While holding the work piece, slide the tailstock to meet it and lock the tailstock in place.
Turn the Handwheel to apply light holding pressure to the work piece; it should turn
easily by hand, yet not be loose. Tighten the Quill Lock.
8 19
Содержание Nova Mercury
Страница 1: ...Nova Mercury TM Woodlathe Part No 100 0109 002 Updated 14 October 2003 O P E R A T I N G M A N U A L ...
Страница 8: ......
Страница 25: ...Nova Mercury Woodlathe Exploded View See parts list on page 25 8 25 ...
Страница 30: ...Nova Mercury Woodlathe Manual Publication Code 100 0109 002 Teknatool International 2000 2003 30 ...