Mounting the Lathe to a Support Surface
1.
Place the lathe on the stand or bench
top (as illustrated). Locate the front
edge of the lathe approximately
25 mm (1 in.) from the front of the
stand/bench top. Locate the left edge
of the lathe approximately 10mm
(3/8") in from the edge of the
stand/bench top. This provides a
comfortable reach when turning and
allows the optional outrigger unit to be
easily installed.
2.
It will be useful to include spacer
blocks under the headstock and
tailstock end of the lathe. This will
create a gap under the motor so wood
shavings, chips and dust can be
removed. The alternative is that the 4
Rubber & Steel washers that are
supplied with the Bench fastening kit
be used with the Steel washer on top
of each Rubber washer. This will also
work as a vibration dampener.
3.
If necessary, mark the four hole
locations (as illustrated) and drill
12mm (1/2-inch) holes.
4.
Place a spirit level along the top of the
lathe bed. Any movement of the
bubble as the lathe is secured,
indicates a twist on the bed. For the
lathe to operate correctly the bed must
not twist; if necessary, use shims between the bed and stand top.
5.
To bolt the lathe to the bench Teknatool have available as
6.
accessories M10x20 Hex bolts-for bolting down to a thin sheetmetal bench or M10x70
Hex bolts or bolting down on a heavy wooden bench up to 2" thickness. The bolts are
supplied in kit form with four of each length bolt. Disregard the bolts not required.
The lathe must be mounted 1 to 1 1/2" on packers or the 4 x Rubber & Steel spacer washers
to avoid wood shavings from entering the motor housing.
Packers
8 13
Содержание Nova Mercury
Страница 1: ...Nova Mercury TM Woodlathe Part No 100 0109 002 Updated 14 October 2003 O P E R A T I N G M A N U A L ...
Страница 8: ......
Страница 25: ...Nova Mercury Woodlathe Exploded View See parts list on page 25 8 25 ...
Страница 30: ...Nova Mercury Woodlathe Manual Publication Code 100 0109 002 Teknatool International 2000 2003 30 ...