Teknatool Nova Mercury, Руководство по эксплуатации

Страница: 12 / 30

Assembling the Tailstock
Handle
Screw the handle into the locking
stud clockwise until it is tight.
Installing Handle
Adding an Extension Bed
Each cast iron extension bed adds 300
mm (12 in.) to the lathe's capacity to turn
between centers.
1. Clean the joining ends of both bed
sections with a petroleum-based
solvent. Make sure there are no
dents or burrs on either mating
surface. Remove burrs and high
spots with a smooth file.
2. Bring the 2 mating faces together
and fit the 2 M10 cap screws, doing
them up "finger tight".
!
Warning!
Do not use a metal hammer to pound on the extension bed. This
may damage the bed, affect accuracy and tailstock action, and may
prevent you from adding another extension bed.
3. Bring the Tailstock along until it is on top of the join area where the bed extension face
meets the lathe bed face. The bed extension may need to be manipulated up-and-down
and sideways in order for the Tailstock to fit.
4. Clamp the Tailstock down in its current position.
5. Do the M10 cap screws up tight.
6. Check that the tailstock moves freely over the mating joint and also over the full length of
the add-on extension. If there is ridge between the two mating surfaces then repeat
steps 1-5 again or failing that use a smooth file to file the surfaces flush.
12