Teknatool Nova Mercury, Руководство по эксплуатации

Страница: 10 / 30

Setting Up Your Workshop
Workshop Requirements
Consideration Recommendation
Lathe
Location Locate the Nova Mercury close to a power source in an area with
good lighting. Allow for outrigger room should this accessory be
purchased. If you are using it in a workshop other machines in your
shop should not interfere with the operation of the lathe.
Lighting Your room or workshop should have adequate lighting. The work
area of the lathe should be well lit; there should not be shadows
cast on your work. If possible, locate near a window. A movable
spotlight may be helpful.
Electrical The Nova Mercury requires the appropriate outlet nearby to power
the motor. Wiring and outlets should adhere to local electrical
codes. If in doubt, seek advice from an electrician. Minimize use of
extension cords.
Ventilation Your room or workshop should be adequately ventilated. The
degree of ventilation will vary based on the size of the room and the
amount of work done. The Nova Mercury lathe does not normally
create a big dust problem however the use of dust collectors and
filters will minimize risks to your health.
Lathe Stand Recommendations
A sturdy and rigid stand is desirable so that the Nova Mercury Woodlathe can deliver
optimum performance. The larger the size of your turnings, the greater the importance of the
lathe stand design. However for many smaller projects simply mounting the mercury on a
bench top or table will suffice. For security it should be clamped in place.
Consideration Recommendation
Lathe Height
from floor The height of the stand should locate the centerline of the lathe
spindle at the elbow height of the turner.
Stand Top The stand top should be flat so the lathe does not twist when it
is bolted down. Check for any gaps between lathe feet and
stand top before bolting down. Shim and prepare stand as
necessary.
Ideally the lathe should be mounted on spacer blocks to provide
extra clearance for motor and shavings.
Stand Weight The stand should have enough weight and mass so it doesn't
move when turning large work pieces, and so that the stand
can absorb vibrations.
Stand Legs The stand should sit level on the floor and not rock.
10