2
Precautions for operation
Examination before installation
Every T-verter has been fully tested and examined before shipment. Please carry out the following
examination procedures after unpacking your T-verter.
z
Check to see if the model number of the T-verter matches the model number of the T-verter
that you ordered.
z
Check to see whether any damage occurred to the T-verter during shipment. Do not connect
the T-verter to the power supply if there is any sign of damage.
Before turning ON power
CAUTION
Choose the appropriate power source with correct voltage settings for the input voltage
specification of the T-verter.
WARNING
Special care must be taken while wiring the primary circuitry terminals. The (L1) (L2)
and (L3) terminals must be connected to the input power source and must not be
mistakenly connected to (T1) (T2) or (T3) output terminals. This may damage the
T-verter when the power is turned on.
CAUTION
z
Do not attempt to transport the T-verter by the front of the cover. Securely hold the
T-verter by the heat-sink mounting chassis to prevent the T-verter from falling, this
may cause personnel injury or damage to the T-verter itself.
z
Install the T-verter onto a firm metal base plate or another non-flammable type
material. Do not install the T-verter onto or nearby any flammable material.
z
An additional cooling fan may need to be installed if several T-verters are installed
into one control panel. The inside temperature inside an enclosed panel should be
below 40 degrees to avoid overheating.
z
Turn off the power supply before proceeding to remove or perform any work on any
panel. Carry out installation procedures according to instructions given in order to
avoid a situation resulting in an operational malfunction.
z
This product is not provided with over speed protection.
z
Only intended for use in a pollution degree 2 macro environment or equivalent
