TEC Sterling, Руководство пользователя, Страница: 9 / 26

Installing Your LP Gas Cylinder
NOTICE:
FOR YOUR SAFETY, ONLY USE THE
REGULATOR AND HOSE ASSEMBLY PROVIDED AS
ORIGINAL EQUIPMENT WITH YOUR GRILL OR, IF
REPLACEMENT PARTS ARE NECESSARY, USE ONLY
TEC SPECIFIED REPLACEMENT PARTS.
NOTICE:
A FIRE EXTINGUISHER FOR CLASS A, B, C &
D FIRES SHOULD BE READILY AVAILABLE AT ALL TIMES.
WARNING:
THE VENTILATION/ACCESS OPENING FOR
THE TANK, IN THE REAR OF THE CABINET, MUST BE
FREE AND CLEAR FROM DEBRIS. THE GAS MUST BE
TURNED OFF AT THE SUPPLY CYLINDER WHEN THE
GRILL IS NOT IN USE.
Be sure to set the gas cylinder upright so the Cylinder
Valve is at the top. This will ensure proper vapor
withdrawal.
Procedure:
1. In order to make sure the Cylinder Valve is fully
closed, turn the Handwheel clockwise until it stops.
2. Turn all Burner Output Knobs to OFF.
3. Move your grill to an open area that’s level and
engage the Base Brake. (See Figure 10, Page 11)
4. Place the gas cylinder in the space provided in the
base and secure the tank with the tank strap latch
assembly (See Figure 3.) Remove the protective caps
from Cylinder Valve Outlet and Nipple, as necessary.
5. Inspect the Coupling Nut, Nipple and Cylinder
Valve for any damage, dirt or debris. Remove dirt or
debris. Replace any damaged parts with TEC
specified replacement parts prior to use.
6. Inspect Regulator and Hose Assembly. See if there is
any damage, dirt or debris. Remove dirt or debris.
Replace any damaged parts prior to use.
7. With the Regulator in your hand, insert the Nipple
into the Cylinder Valve. Make sure the Nipple is
centered in the Cylinder Valve Outlet. Tighten the
Coupling Nut by hand, making sure not to cross-
thread the connection.
Please note that when you connect your cylinder to the
grill, you will feel the coupling nipple seal when there is
slight resistance. (See Figure 2.) Turn about one-half to
three-quarters further to complete the connection. Tighten
only by hand; do not use tools. If you cannot complete
the final connection, disconnect the regulator and repeat
step 7, above. If you are still unable to complete the
connection, replace the valve and/or regulator!
7
Gas Connection
continued
COUPLING
ASSEMBLY
Figure 3
. Gas Tank Placement
Handwheel
Excess Flow
Valve
Cylinder
Valve
Cap & Strap
Valve
Outlet
Coupling
Nut
Regulator
Nipple
Figure 2.
Coupling Assembly