TEC Sterling, Руководство пользователя, Страница: 6 / 26

4
Revised 9/04
Installation..................................................4
General Overview
Assembly ...................................................5
General Overview
Radiant Glass Emitter
Cooking Grids and Warming Rack
Gas Connection......................................................6
General Overview
LP Gas Cylinder Safety
Installing Your LP Gas Cylinder
Removing Your LP Gas Cylinder
Quick Disconnect Instructions
Natural Gas Installation
Gas Leak Test
Operation ............................................................9
General Overview
Burner Ignition
Burner Ignition With Match
Low Heat Adjustment
Base Brake
Hazardous Locations and Conditions
Infra-red Cooking ..................................................12
General Overview
Infra-red Searing Method
Smoking Method
Helpful Hints in Cooking
Flame Flare-up Control
Sample Cooking Methods
Maintenance and Cleaning ......................................14
General Overview
Maintenance
Care of Radiant Glass Emitter
Protection of Burners
Spark Module Battery Replacement
Cleaning
Replacement Parts
Appendix A: Build-in Specifications ..........................16
Appendix B: Accessories ........................................17
Rotisserie
Deep Fryer/Steamer
Steamer
Griddle
Wok
Appendix C: Replacement Parts................................22
Appendix D: Troubleshooting ..................................23
General Overview
WARNING:
THIS GRILL IS DESIGN CERTIFIED FOR
USE OUTDOORS ONLY. THIS GRILL SHOULD NOT BE
USED IN A BUILDING, GARAGE OR OTHER ENCLOSED
AREA AND IS NOT INTENDED FOR USE ON
RECREATIONAL VEHICLES OR BOATS.
WARNING:
THIS OUTDOOR COOKING GAS APPLIANCE
SHALL NOT BE USED UNDER OVERHEAD
COMBUSTIBLE CONSTRUCTION.
Sterling
®
G-Series grills are designed to be built-in using a
permanent masonry or other suitable patio fixture or for
mounting onto a mobile cabinet base. See Appendix A
for complete build-in specifications. Figure 1, page 5,
shows the minimum required clearance of a mobile
G-Series grill to any adjacent combustible construction.
Instructions for permanent installation and for cabinet
mounting assembly follow.
Permanent Installation
If you are installing your grill as a build-in, it should be
located so the ventilation openings remain clear of all
obstructions. The openings are located in the front
surface of the grill Housing and at the rear of the Roll
Back Hood. Any accumulation of debris will restrict the
flow of combustion and /or ventilation air, and may
result in improper burner operation or overheating. See
Appendix A for clearance specifications. Installation
procedures relating to gas connections for permanent
installations can be found in the Gas Connection section
of this manual. Build-in opening specifications can be
found in Appendix A of this manual.
The installation of your grill must conform to local codes
or, in absence of local codes, the National Fuel Gas Code
ANSI Z223.1/NFPA 54. In Canada, the installation
must conform to local codes and/or the Natural Gas and
Propane Installation Code CAN/CGA-B149.1.
Cabinet Base Mounting Instructions
The Sterling G-Series grill designed for cabinet mounting
is packaged separately from the Cabinet Base. Follow the
procedures below to mount the Grill Housing onto the
Cabinet. Two open-end 7/16” wrenches are required.
Contents Installation