TEC Sterling, Руководство пользователя, Страница: 17 / 26

Spark Module Battery Replacement
1. Turn PUSH BUTTON counter-clockwise one-
quarter turn and pull out to remove. DO NOT turn
and remove the BEZEL (See Figure 12).
2 Remove old battery and replace. Insert the positive
(+) end of the battery in the Spark Module first.
3. Replace PUSH BUTTON, pushing in and turning
clockwise to tighten.
Cleaning
CAUTION:
ALWAYS ALLOW THE GRILL TO COOL
BEFORE CLEANING.
Radiant Glass Emitter
Cleaning required to maintain proper function of the
Radiant Glass Emitter is discussed under Care of Radiant
Glass Emitter at left. The cosmetic appearance of the
glass may be improved through additional cleaning with
ceramic cleaning creams. The following are the cleaning
creams approved by the glass manufacturer:
■
ELCO/Weimann CookTop Cleaning Creme
■
Golden Ventures Cerama Bryte
■
Hope’s Cooktop Cleaning Cream
■
Whirlpool Cooktop Cleaner
WARNING:
DO NOT USE ABRASIVE SPONGES OR
SCOURING PADS OF ANY TYPE. DO NOT USE
CORROSIVE CLEANERS SUCH AS OVEN SPRAYS,
STAIN REMOVERS, OR CLEANERS CONTAINING
CHLORINE OR AMMONIA.
Prior to using an approved cream, scrape off any charred
residue and wipe glass with a damp paper towel as
described under Care of Radiant Glass Emitter. With a
cool surface, apply a few dabs (the size of a dime) of an
approved cleaner and work the cleaner over the glass with
a damp paper towel as if you were cleaning a window.
Clean the glass with clear water and wipe with a clean,
dry paper towel.
Drip Tray
Remove debris and rinse with soap and water.
Heat Shield
If necessary, the Heat Shield may be removed for
cleaning (See Figure 13).
Cooking Grids
Leave the Cooking Grids in place for 5-10 minutes while
the burners are on HIGH and the hood OPEN. The
Cooking Grids may also be removed and cleaned with a
brass or stainless steel bristle brush and soapy solution.
Standard oven cleaners may be used for further cleaning.
Wash the Cooking Grids thoroughly with dish detergent
and warm water before using.
Replacement Parts
If you need Replacement Parts or Accessories, contact
your TEC Authorized Dealer. See Appendix C of this
manual for a listing of Replacement Parts and
Accessories.
Maintenance and Cleaning
continued
15
Figure 11.
Burner Ignition Electrode Location
Figure 13.
Heat Shield Removal
Figure 12.
Spark Module Battery Replacement
HEAT SHIELD
BATTERY COMPARTMENT
SPARK
MODULE
BEZEL
“AAA” BATTERY
PUSH BUTTON