6-45
6. DIAG. TEST OPERATION
EM18-33011
6.4.2 Process Test Print
In the process test print, the test print is automatically performed under the following conditions.
Parameter setting and print tone fine adjustment value is ignored.
•
OPERATION :
One label feed, 3-dot slant line print, bar code print, character print
•
ISSUE COUNT :
5 labels each
•
PRINT SPEED :
8 inches/sec.
•
SENSOR :
Transmissive sensor (feed gap sensor) or reflective sensor (black
mark sensor)
•
RIBBON :
Transmissive ribbon
•
TYPE :
Batch (without cut)
•
LABEL LENGTH :
76 mm
•
PRINT TONE FINE ADJUSTMENT VALUE :
+0
Operating procedure for the test mode is provided below.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
< 1
D I A G .
V 1 . O A
>
Press the [FEED] key twice.
Press the [RESTART]
key.
Press the [FEED] key
and [RESTART] key
at the same time.
< 3
T E S T
P R I N T
>
P R
N T
C O N D I T I O N
I
A U
O
P R I N T ( R E F L )
T
Press the [PAUSE] key.
Press the [PAUSE] key.
Press the [RESTART] key.
[Bar codes are printed on 5 labels.]
After feeding one label, slant
lines (3 dots) are printed on 5
labels.
From
C
on
the next page.
To
A
of the
preceding page.
To
C
of the
preceding page.
To be continued on
B
of the next page.
6.4 TEST PRINT MODE
