6-30
6. DIAG. TEST OPERATION
EM18-33011
6.3.11 Strip Wait Status Setting
(Revision Date: Dec. 10 '96)
6.3 PARAMETER SETTING MODE
NOTE:
When the status type 1 is selected, the printer will send (00H) in response to the status request
command sent from the PC while a label stays at the strip sensor (when idling, after feeding,
or all printing finished).
When the status type 2 is selected, the printer will send (05H) in response to the status request
command sent from the PC while a label stays at the strip sensor (when idling, after feeding,
or all printing finished.)
If the status request command is sent during printing, the printer will always send (05H)
regardless of the setting.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
< 1
D I A G . V 1 .
>
Press the [FEED] key.
< 2
P A R A M E T E R
S E T
>
Press the [PAUSE] key thirteen times.
S
A T U S
T
T
Press the [FEED] or
[RESTART] key to select
the strip wait status.
Press the [FEED] and
[RESTART] key at the same
time. (See NOTE 1.)
Press the [PAUSE] key.
(See NOTE 1.)
P E
Y
[FEED] key:
Status type 2: A strip wait status is sent.
[RESTART] key:
Status type 1: A strip wait status is not sent.
0 A
1
