6-5
6. DIAG. TEST OPERATION
EM18-33011
2) Parameters
(Revision Date: Dec. 10 '99)
6.2 SELF TEST MODE
#
(11)
(12)
(13)
(14)
(19)
(15)
(20)
(16)
(21)
(17)
(22)
(18)
(23)
(24)
(25)
(26)
(27)
(28)
(29)
(30)
(31)
(32)
(33)
Contents
PC-850 :
PC-850
PC-8
:
PC-8
0
: No slash used.
0
: Slash used.
AUTO
:
Automatic selection
ESC LF NUL
:
ESC LF NUL mode
{ }
:
Mainframe mode
1B 1C 1D
:
Manual
TRANS.
:
Transmissive ribbon
NON TRANS.
:
Non-transmissive ribbon
-50.0 mm to +50.0 mm
-50.0 mm to +50.0 mm
-9.9 mm to +9.9 mm
-10 step to +10 step
-10 step to +10 step
-99.5 mm to +99.5 mm
0.0V to 4.0 V
0.0V to 4.0 V
-15 Strip to +0 Step
1: Strip wait status is not sent to the PC.
2: Strip wait status is sent to the PC.
TYPE1:
Windows code
TYPE2:
Original code
TYPE1:
SANYO motor
TYPE2:
NMB motor
20H to FFH
DTR: READY/BUSY (DTR) protocol (DTR/DSR)
RTS: READY/BUSY (RTS) protocol (RTS/CTS)
ON:
The printer will restore to the initial status.
OFF: The printer will not restore to the initial status.
Item
Character code selection
Font zero selection
Control code selection
Ribbon type selection
Feed length fine adjustment
(PC), (KEY)
Cut/strip position fine adjustment
(PC), (KEY)
Back feed length fine adjustment
(PC), (KEY)
Print tone fine adjustment
(Thermal transfer ) (PC), (KEY)
Print tone fine adjustment
(Thermal direct) (PC), (KEY)
X axis fine adjustment
Threshold manual fine adjustment for
the black mark sensor
Threshold manual fine adjustment for
the feed gap sensor
Ribbon Motor
STATUS
Kanji code type
(Not supported by QQ/QP models)
MOTOR
EURO font code setting
Transmission Control Mode
Reset selection when the
INPUT • PRIME signal is ON.
