3-5
3. INSTALLATION PROCEDURE FOR THE OPTIONAL EQUIPMENT
EM18-33011
■
Adjusting the Cutter Guide Plates
After replacing the cutter unit the following adjusting procedure should be employed to prevent
paper jams.
1. Attach the cutter guide plate A with two SM-4 x 6C screws so that the fixed cutter is positioned
0.1 mm to 0.4 mm above the bottom of the cutter guide plate A.
2. Attach the cutter guide plate B with two FL-4 x 8 screws so that there is a clearance of 0.5 mm between
the cutter guide plate A and cutter guide plate B using a clearance gauge.
(Revision Date: Aug. 11 '95)
3.3 Memory Module
Fig. 3-7
Screw (SM-4x6C)
Cutter Guide Plate A
Cutter Guide Plate B
Screw (FL-4x8)
Fixed Cutter
0.1-0.4 mm
0.5 mm
3.3 Memory Module
1. Remove the top cover and left side cover. (See Fig. 2-1.)
2. Hold the memory module so that the Pin 1 is on the upper right, then solder the memory module to
the CPU PC board. Expanding the memory must be performed in sequence, IC21 and IC22.
Fig. 3-8
3. Reassemble the left side cover in the reverse order of removal.
