Teac DS Series, Инструкция по эксплуатации, Страница: 12 / 104

Page 4
1.4 Pin Assignment of Input/Output Connector
This paragraph explains the relationship between the pin assignment and the channel numbers.
Pin Number
Channel Number + - Ground
1 15 16 32
2 13 14 30
3 11 12 28
4 9 10 26
5 7 8 24
6 5 6 22
7 3 4 20
8 1 2 18
9 48 49 33
10 46 47 31
11 44 45 29
12 42 43 27
13 40 41 25
14 38 39 23
15 36 37 21
16 34 35 19
Add 16 x (Slot Number - 1) to the channel number above for Slot 2
or later.
Input/Output Connector:
D-SUB 50 pin HIROSE RDDB-50S
Connector of Signal Input Cable:
HIROSE HDDB-50P(soldering type), JAE DD-50PF-N(soldering type), or equivalent.
CAUTION
Do not connect any signal at Pin 17.
Installation of accessory clamp filter
Install the clamp filter included in the accessory around the INPUT/OUTPUT cable to reduce
unneccessary electric wave radiation.
Install one clamp filter on a cable by latching it in the vicinity of the connector which attaches to
the DS amplifier.
Note:
There are four clamp filters (ferrite
cores) included regardless of the
number of installed amplifiers or type of
models .
Pin No 50, 33,
and 17 from left.
Pin No 34, 18, and 1 from left
To be labeled as “OUTPUT” for the output connector