TAYO ZONTES 310T-M 2022, Руководство по обслуживанию

Страница: 54 / 188

54 / 188
c. Remove the decorative buckle
⑻
of the M6 hexagon
socket bolt; remove the M6×16 bolts ⑶ on both sides with
4# hex socket.
d. Grasp the tail skirt of the storage box and pull it upward
obliquely, paying attention to the cables iny the battery
compartment. Pull up to see the left side of the glove box
atmosphere lamp thread, unplug the thread and remove the
glove box assembly.
e. Use 4# inner hexagon to loosen 2 pcs bolts come with
the pipe clamp.
Rotate the throttle body so the stepper motor plug is
facing up.Unplug the plug of the stepping motor ① .
f. Use a short Phillips screwdriver to remove the 2
GB9074.4 M4×12bolts ③ and the anti-off card ④ that come
with the throttle valve body assembly, and then remove the
stepping motor.
g. Use throttle cleaner to clean the carbon deposits on the
head of the stepper motor. Spray a small amount of cleaning
agent into the valve body hole. It is forbidden to soak the
stepper motor with any liquid.
o. Install the stepper motor back to the valve body, paying
attention not to miss the sealing ring. Plug the plug back in.
3. Remove the throttle valve body assembly to
clean up carbon deposits
a. Refer to the previous steps to loosen the bolts that
come with the clamp, then rotate the throttle valve body
assembly so that the stepping motor plug faces upwards.
Unplug the stepping motor and throttle position sensor
plugs.