TAYO ZONTES 310T-M 2022, Руководство по обслуживанию

Страница: 92 / 188

92 / 188
Side bracket
Caution:
●Park the vehicle on a flat and stable ground or a lifting
platform, and put down the main support.
●When disassembling and installing the spring, it is necessary
to prevent the spring from flying off suddenly and causing
personal injury.
1. Check
1. Side bracket 2. Side bracket spring 3. Side bracket flameout
switch
①Parking position② Driving position
a. Check whether the side bracket spring is damaged and
whether the elastic force is normal.
b. Check whether the side bracket rotates normally.
Turning to the angle shown in Figure 1 should be able to
automatically turn to the parking space under the spring
force; when the angle in Figure 2 is turned to the parking
space automatically. If necessary, remove the side bracket for
lubrication.
c. Check whether the flameout switch function is normal.
The vehicle should not be started when the side bracket is
lowered (parking position); the vehicle cannot be started
when the side bracket is retracted (driving position) without
pinching the front or rear brake handle; After starting the
vehicle, put down the side brackets, and the flame should be
automatically turned off, otherwise it is necessary to
troubleshoot the flameout switch or brake switch failure.
d. Check whether the side bracket mounting plate is
deformed or cracked.
2. Lubrication
a. Put away the side bracket so that the spring is in the
shortest position for easy disassembly.
b. The thick steel wire can be rolled into a circle and put
into the spring
⑴
pull hook. Pay attention to ensure that the
steel wire cannot loose or fall apart during the pulling
process.
C. Grasp the side bracket with one hand, and pull it in the
direction of the arrow with the other hand to remove the
spring.
d. Put down the side bracket, and use a 14# sleeve or torx
wrench to remove the nut ⑵ counterclockwise. After holding
the side bracket firmly, use a 14# sleeve to remove the bolt ⑶
counterclockwise, and take off the side bracket.
e. Remove the side bracket bushing ⑷ from the frame.
f. Use diesel or kerosene, or a clean cloth to wipe off the
remaining grease. Apply a proper amount of grease to the
two installation planes inside the side bracket and the surface
that matches the flameout switch, and try not to apply it to
the threaded holes.