TAYO ZONTES 310T-M 2022, Руководство по обслуживанию

Страница: 171 / 188

171 / 188
j. Locate and unplug the tube connecting the throttle body
to the carbon canister at the lower part of the throttle body.
k. Locate and unplug the pipe connecting the oil and gas
separator to the air filter on the left side of the throttle body.
l. Use a 4# inner hexagon to remove one M6×12 bolt that
fixes the wheel speed sensor on the rear rocker arm, take out
the wheel speed sensor and take it out of the fixed clamp.
Then use a 14# sleeve to remove the two M8×37 bolts that
fix the brake caliper, and pass the brake caliper and wheel
speed sensor in the direction of the arrow from the middle of
the shock absorber.
4. Disassemble the engine
a. Use a 12# sleeve to remove the two M8×25 bolts that fix
the right pedal bracket, and remove the rear right pedal
assembly.
b. One person uses a 17# torx wrench to insert a M12 nut
that fixes the engine on the left side of the vehicle from the
front of the air filter, and another person uses a 15# sleeve to
remove a M12×1.25×290 bolt that fixes the engine on the
right side of the vehicle, pull out the bolt from the frame.
c. One person uses 14# torx wrench to extend from under
the tail skirt and fix the 1 M10×1.5×55 bolt on the top of the
left rear shock absorber, and one person uses 14#
ratchet wrench to remove and fix the left side from the
frame. One M10 nut for rear shock absorption, and a bolt of
M10×1.5×55 is drawn out. Use the same method to remove
the 1 M10 nut that fixes the right rear shock absorber, one
person holds the frame, and the other uses a rubber hammer
+ suitable tools to knock out one M10×1.5×55 bolt that fixes
the right rear shock absorber.
d. Two people hold the left and right handlebars and the
frame respectively, push the whole car forward, push it to a
flat and wide place, lay down the side brackets, and use a
rubber stool with a suitable height to support the right side
of the vehicle. Keep the vehicle balanced.
5. Install the engine
a. Two people cooperate to push the whole car to a
suitable position, and first place the rear brake caliper on the
whole car on the disc brake disc, being careful not to knock
the shock absorber. Another person holds the vehicle, and
one person adjusts the cradle mounting hole on the vehicle
frame to align with the engine mounting hole. After aligning,
use a suitable tool to penetrate a M12×1.5×290 bolt.