TAYO ZONTES 310T-M 2022, Руководство по обслуживанию

Страница: 178 / 188

178 / 188
b. Grasp the mark on the front left panel (green rectangle)
with both hands, and carefully pull out in the direction of the
big arrow. When pulling out, you need to follow the order of
the small arrow pointing to separate 11 buckles (Yellow area;
4 front vents, 1 decorative cover on the left panel of the
front storage box + 1 mushroom button, 6 front storage box
panels), and 1 mushroom buckle (Blue area) on the
connection of the front left panel and the front vent, the
front storage box left panel decorative cover, the front
storage box front panel, remove the front left panel.
c. Use the same method to remove the front right panel.
Removal of the front part of vent
Use 4# inner hexagon to remove the 2 swell nails on the
inside of the front part of vent. Then unplug the 3 connectors
on the upper left side of the front vent.
Caution: When unplugging the connector, you need to
press down the lower tip of the connector before pulling it
out, otherwise the connector buckle will be damaged.
Use 5# inner hexagon to remove 4 M6×14 bolts on the
front vent. Remove the front vents and the position lights
installed on the vents and other parts.
Caution: When removing the last bolt, you must hold the
front vent with your hand to prevent the front vent from
falling directly and scratching the paint.
Removal of the windshield base
a. Use a 4# inner hexagon to remove the M6×16 bolts that
fix the bracket. Locate the two plugs of the windshield
controller and unplug them.
b. Use an 8# sleeve to remove the M6×30 bolts on the left
side of the auxiliary water tank and the M6×30 bolts on the
right side to remove the main water tank from the base.
Remove the auxiliary tank drain hose from the windshield
base. Remove the horn bracket using a 6# Allen. Use an 8#
sleeve to remove the water filler bracket and remove 2
M6×16 bolts.
c. After holding the windshield base assembly firmly, use a
12# sleeve to remove 3 M8×25 bolts, and then remove the
windshield base assembly from the vehicle.
d. Use a 4# socket head to remove 2 M6×16 bolts and take
off the flanged bushing. Remove the windshield control.
e. Use needle-nose pliers to remove the two retaining
springs, grab the left windshield bracket and remove the pin