Taylor C606, Руководство оператора

Страница: 96 / 122

90 Model C606
Operating Procedures
Step 10
Repeat steps 1 through 8
for the soft serve side of
the freezer.
Disassembly - Shake Side
Note: Failure to remove the parts specified below
for brush cleaning and lubrication will result in
damage to the machine. These parts must be
removed every 14 days or the machine will lock out
and will not operate.
Step 1
Be sure the power switch is in the OFF position.
(See Figure 228.)
Figure 228
Step 2
Remove the hole plugs from the syrup ports, and
remove the restrictor cap from the bottom of the
door spout.
Step 3
Remove the spinner blade from the bottom of the
door spout by lifting up the locking collar on the
spinner coupling and pulling down the blade.
Step 4
Remove the handscrews, freezer door, beater
assembly, drive shaft, drive shaft seal, and scraper
blades from the freezing cylinder.
Step 5
Remove the drive shaft seal from the drive shaft.
Step 6
Remove the freezer door o-ring, front bearing,
retainer pins, and the draw valve spinner assembly.
Remove the driven spinner from the draw valve by
grasping the draw valve and pulling the driven
spinner out. Remove the spinner shaft seal.
(See Figure 229.)
Figure 229
Step 7
Remove the two o-rings from the draw valve.
Note: To remove o-rings, use a clean, sanitized
towel to grasp the o-ring. Apply pressure in an
upward direction until the o-ring pops out of its
groove. With the other hand, push the top of the
o-ring forward and it will roll out of the groove and
can easily be removed. If there is more than one
o-ring to be removed, always remove the rear o-ring
first. This will allow the o-ring to slide over the
forward o-rings without falling into the open grooves.
Step 8
From the shake pump cylinder, remove the retaining
pin, mix inlet adaptor, valve cap, pump gasket, and
the piston. Remove the o-ring from the piston and
valve cap.
Step 9
Remove the pump drive shaft from the drive hub in
the rear wall of the mix hopper. (See Figure 230.)
Figure 230