67
Model C606
Operating Procedures
150619
Step 11
Place the agitator on the agitator drive shaft
housing. (See Figure 157.)
Figure 157
Note:
If agitator should stop turning during normal
operation, with
sanitized hands
, remove agitator
from agitator drive shaft housing and brush clean
with sanitizing solution. Install the agitator back onto
the agitator drive shaft housing.
Step 12
Remove the cotter pin from the pump. Stand the mix
feed tube in the corner of the mix hopper. Place the
cotter pin in position in the outlet fitting of the pump.
(See Figure 158.)
Figure 158
Note: You have just sanitized all food contact
surfaces of the freezer.
Priming - Shake Side
Note:
Use only FRESH MIX when priming the
freezer.
Step 1
With a pail beneath the door spout, touch any
FLAVOR SELECT symbol
to open the draw
valve. Pour 2-1/2 gallons (9.5 liters) of FRESH mix
into the mix hopper and allow it to flow into the
freezing cylinder. This will force out any remaining
sanitizing solution. When full strength mix is flowing
from the door spout, touch any FLAVOR SELECT
symbol
to close the draw valve.
IMPORTANT! Failure to remove all sanitizing
solution may result in damage to the freezing
cylinder.
Step 2
When mix stops bubbling down into the freezing
cylinder, remove the cotter pin from the outlet fitting
of the mix pump. Insert the outlet end of the mix
feed tube into the mix inlet hole in the mix hopper.
Place the inlet end of the mix feed tube into the
outlet fitting of the mix pump. Secure with cotter pin.
(See Figure 159.)
Figure 159
Содержание C606
Страница 6: ...Table of Contents Model C606 Notes ...
Страница 16: ...10 Model C606 Operator Parts Identification 140624 Front View Figure 2 ...
Страница 26: ...20 Model C606 Operator Parts Identification 140624 Accessories Figure 11 ...
Страница 30: ...24 Model C606 Operator Parts Identification Beater Door Assembly Shake Side Figure 14 ...