72
Model C606
Operating Procedures
Step 6
Prepare a small amount of an approved 100 PPM
sanitizing solution (examples: Kay-5® or
Stera-Sheen®). USE WARM WATER AND
FOLLOW THE MANUFACTURER'S
SPECIFICATIONS. Brush clean the parts.
Step 7
Prepare a small amount of an approved 100 PPM
sanitizing solution (examples: Kay-5® or Stera-
Sheen®). USE WARM WATER AND FOLLOW THE
MANUFACTURER'S SPECIFICATIONS. Sanitize
the agitator and hopper cover.
Step 8
Install the agitator back onto the agitator drive shaft
housing. Replace the hopper cover.
Important:
If you do not install the agitator correctly,
the machine will fail the heat cycle and will lock out
in the morning.
Step 9
Return to the freezer with a small amount of
cleaning solution. Dip the door spout brush into the
cleaning solution and brush clean the door spout
and bottom of the draw valve.
Note:
To assure sanitary conditions are maintained,
brush each item for a total of 60 seconds, repeatedly
dipping the brush in cleaning solution.
(See Figure 172.)
Figure 172
Step 10
Remove, clean and reinstall the long drip pan
through the front panel. (See Figure 173.)
Figure 173
Step 11
Remove, clean and reinstall the two short drip pans
in the rear panel.
Step 12
Remove, clean and reinstall the two notched drip
pans in the left and right side panels.
(See Figure 174.)
Figure 174
Step 13
Using a clean, sanitized towel, wipe down the
freezer door, front panel, the area around the bottom
of the freezer door, and any other areas that
demonstrate a build-up of either moisture or food
substance.
The heat cycle will start at the AUTO HEAT TIME
setting in the Manager's Menu (see page 42).
There are three phases of the heat cycle: Heating,
Holding and Cooling. Each phase has a time limit. If
any one of the three phases fail to reach the proper
temperatures within the time limit, the cycle will
Содержание C606
Страница 6: ...Table of Contents Model C606 Notes ...
Страница 16: ...10 Model C606 Operator Parts Identification 140624 Front View Figure 2 ...
Страница 26: ...20 Model C606 Operator Parts Identification 140624 Accessories Figure 11 ...
Страница 30: ...24 Model C606 Operator Parts Identification Beater Door Assembly Shake Side Figure 14 ...