VERTICAL TOWED MIXER - ONE AUGER
VN & V SERIES
Tatoma Ag Equipments Corp. Located in Colcord, OK. Phone (918) 422-4271
- 23 -
L U B R I C A T I O N C H A R T
COMPONENT
TYPE OF LUBRICANT
INTERVALS
Unloading conveyor
Light oil
Brush or spray lightly every
40 hours of operation.
Bearings
Good quality grease
Every 8 hours
Drive Shaft
Power take off
Good quality grease
Every 8 hours
At each lubrication, make
sure the PTO shaft enters
and exits freely, any slip
fault can cause damage to
the drive shaft.
Wheel bearings
Lithium based grease
Every 12 months
Universal joints
Good quality grease
Every 8 hours
CV joints
Good quality grease
Every 8 hours
Hydrostatic system
Hydraulic fluid:
T-04SAE10W
Only when the system has
been contaminated
Oil filters
24 hours after system startup.
Regular maintenance every 500 hours.
AT THE END OF THE WORK.
At the end of the operation:
- adjust the brakes,
- disconnect all power units,
- turn off the engine and
- remove the ignition keys.
Store the unit in a place away from human activity.
- Do not park the mixer where it may be exposed to animals (specially rodents) for long
periods of time. The equipment could be damaged and cause injury to livestock.
- Do not allow children to play around the stored unit. Make sure the machine is parked
on a hard and leveled surface without compromising the safety devices.
- Use the front jack to park the mixer horizontally. Remember this jack can only support
vertical loads.
- If necessary, place the parking chocks on the wheels to prevent the unit from moving.