User Guide
The control panel
Messages in the LC display
If the printer detects an internal fault or user error or if it expects you to do something, a message will
appear in the LC display. It also displays the status during an operation (e.g.
Initializing
). Below you will
find a list of messages with brief descriptions of each message. The messages are described in greater
detail in the chapter
Error messages via the display
.
Meaning
Eject error
The printer cannot eject the paper/advance it to park
position.
Hardware Alarm
Internal hardware error. Try power cycling the printer. If
the message appears again, contact your dealer or
service technician.
Initializing
This message appears during the printer’s initializing
phase after switching on the printer.
Load error
The printer cannot draw in the loaded paper.
Load paper from
The printer has detected paper end during
operation/printer was switched on with no paper
loaded.
Loading default
Factory defined parameters will be reloaded in all
available menus after switching on the printer.
Out of paper
The printer has detected paper end during operation /
printer was switched on with no paper loaded.
Paperwidth error
Print characters override the detected right paper
margin.
Parity error
A parity error during data transmission is indicated.
Park position
Paper is not being fed into print position.
Press any key
The user is requested to press any key.
PW sensor defect
The automatic paper width detection cannot detect the
left paper margin.
Selftest
After power-on, the printer executes a short hardware
self-test.
Tear Paper off
The user is requested to tear off paper which has been
advanced to the tear edge.
AED Error
AED sensor cannot locate paper transport holes (only
if a cut device is installed).
23
Message
