TALEX Spółka z ograniczoną odpowiedzialnością
Spółka komandytowa
ul. Dworcowa 9c, 77-141 Borzytuchom
tel. (59) 821 13 40
e-mail.
36
It is also necessary to check the tension of V-belts, replace the damaged ones with new
(always replace the whole set of belts). Adjust the whole set in accordance with the
instruction - 7.1 Adjustment of the V-belts tension.
Lubricate the mower according to the instruction – 7.4 Lubrication.
All safety signs placed on the machine should be kept clean.
7.4. Lubrication
All maintenance and servicing works should be done with the switched off
engine of the vehicle, released pressure and stopped rotations, and with
both, the vehicle and machine, properly secured.
Avoid contact with oil!
Use the personal protective equipment: protective clothing, footwear,
gloves and goggles.
Articulated telescopic shaft should be operated and lubricated strictly
according to the operating instructions provided by the manufacturer of
the shaft.
To ensure proper operation of the gearbox:
I)
Every 10 hours check the oil level, using clean rod put into the oil fill opening
(figure A below). The mower should be placed on a flat surface.
The oil level should be between min. 20mm to max. 30mm.
measured from the
bottom of the unit.
II)
Oil level should be additionally checked after every season, and should be refilled
to the levels given below.
III)
Oil does not require changing – only refilling. If the user wants to change the oil,
old oil has to be sucked out through the refill plug on top. (Figure A)
The required quantity of oil in the gearbox:
A.
2.10m
~6 l
B.
1.85m
~ 5 l
C.
1.65m
~ 4 l
D.
1.35m
~ 3.5 l
E.
1.35mini
~ 3,5 l
Figure A – oil fill plug
The machine manufacturer recommends using the oil: SP460 (based on 80W90) + admixture
grease LT-43.
In the event the oil level gets too low, find and repair the leak then fill in the required
quantity.
