TALEX Spółka z ograniczoną odpowiedzialnością
Spółka komandytowa
ul. Dworcowa 9c, 77-141 Borzytuchom
tel. (59) 821 13 40
e-mail.
34
Figure 23 Replacing blades:
The replacement or turning of a blade must be done with the special wrench, according to
Fig. 22.
Insert the wrench between the working disc and holder in such a way that the round
edge of the wrench is placed above the blade’s holder.
Loosen up the holder up to the point, when the blade can be removed.
After checking the blades and holders, install blades in the same spot or in the adjacent disc
(rotating in the opposite direction), under condition that they are not damaged, or replace
them with new ones, then release the wrench’s pressure on a holder. After replacing the
holders and blades, pay attention to their proper position on the particular discs, which is
shown in the following figure.
