TALEX Spółka z ograniczoną odpowiedzialnością
Spółka komandytowa
ul. Dworcowa 9c, 77-141 Borzytuchom
tel. (59) 821 13 40
e-mail.
32
Use only the original spare parts provided by the manufacturer, to guarantee
safe and reliable operation of the machine. The use of unoriginal spare parts or
parts, which have been repaired, will void the warranty.
If all the above listed steps have been performed, and the mechanical condition of the
machine does not raise any doubts, it can be connected to the tractor.
Aggregating of the machine with the tractor is shown in paragraph 6.2 Aggregating –
connecting the mower.
7.1. Adjustment of the V-belts tension
The mower is equipped with a spring loaded belt tensioner. Correct tension of the belts can
be checked through the inspection hole (Fig. 21). Properly tightened belts should give in
slightly under the pressure of the operator’s hand.
In the event of damage to, or an overextension of even one of the belts, you must always
replace the entire set of belts (using the belts with the same markings and the same brand).
Figure 21 Adjustment of the V-belts tension: A) Belt tensioner B) for Eco CUT 210 version
When adjusting the belt tension on the 2.10m mower (Fig. 20 B), unscrew the
lock nut (Fig. 20 - C), adjust the nut closer to the spring (Fig. 20 - D), then
tighten the lock nut (Fig. 20 - C) against lock nut “D”.
A
B
D
C
