TALEX Spółka z ograniczoną odpowiedzialnością
Spółka komandytowa
ul. Dworcowa 9c, 77-141 Borzytuchom
tel. (59) 821 13 40
e-mail.
28
Closing the cylinder for Eco CUT 210 mower for transport is shown in the figure below.
Lock pin -
Pos. 1
should lock into the cylinder handle (lower the mower until the pin is
completely locked). The ball valve lever should be moved to the
closed position - Pos. A.
However, for operation, the valve lever should be moved to the
open position - Pos. B
, and
open the lock with the cable until the lock is released.
6.4. Working position
To transform the transportation position to the working position:
1.
Park the tractor and mower on a flat, even surface,
2.
In the mower with hydraulic cylinder, pull the rope to release the cylinder lock (Fig.
13B), then move the mower to horizontal position. During lowering of the mower
you must exercise extreme caution.
3.
In a model with connectors, set the interlock to working position (Fig. 9B).
4.
Lower mower just above the ground.
5.
Standing at the rear of the machine, pull the rope and remove locking pin from the
clevis (Fig.11B), then rotate the mower to working position (Fig. 10).
In the model 1.35m, remove the transport beam from the top pivot of suspension
frame, then rotate the mower to working position. Place the loose end of the
transport beam into the bracket on suspension frame (drawing of the transportation
beam is shown in paragraph 13.2.5.1 Centre frame - mower 1.35, on page 54).
6.
Mount a securing element on the top pivot of suspension frame, and secure it with a
cotter pin.
Pos. 1
Pos. B
Pos. A
