Tadiran Telecom Coral IPx 500, Руководство по установке

Страница: 60 / 544

2-18
Coral IPx 500 Installation Manual
Eq
uip
m
ent Insta
lla
tio
n
2
0
The process of mounting and installing the wall-mounted cage includes the following
stages:
„ Unpacking the Shipping Container, on page 2-18
„
Checking the Space and Positioning Requirements, on page 2-20
„
Removing the Cage Door and Top Cover, on page 2-20
„
Installing the Cable Support Bracket, on page 2-20
„ Assembling the Left Decorative Cover, on page 2-21
„ Assembling the Right Decorative Cover, on page 2-22
„
Fastening the Bottom Panel Support Bracket, on page 2-23
„
Attaching the Wall Mounting Bracket onto the Wall, on page 2-24
„
Mounting the Cage onto the Wall Mounting Bracket, on page 2-27
Unpacking the Shipping Container
1. Inspect the shipping container for evidence of physical damage or mishandling.
Report any damage to the carrier immediately.
2. If it is necessary to make a damage claim to the carrier, do not move the container
until it has been examined by a representative of the carrier. Otherwise, before
opening, move the container as close as possible to the installation area.
3. Using a utility knife, carefully cut the tape securing the top flaps of the container
and open the flaps.
4. Remove any parts in the depressions of the top foam insert.
5. Remove the top foam insert and set aside.
6. Using an assistant to prevent personal injury (for the MDF, no assistant is
necessary), grasp the ends of the cage/MDF and lift it out of the container. Place
the cage/MDF on a stable surface.
7. Inspect the cage and MDF covers for shipping damage.
8. Check the part list and verify that all the items are present.
Table 2-5
lists the
components that are supplied with the wall-mounted Coral IPx 500 system.
9. Remove any other cage items from the shipping container, and move the container
so that it does not interfere with the remaining installation procedures.
2 Wall Mounted Installations