Tadiran Telecom Coral IPx 500, Руководство по установке

Страница: 418 / 544

8-42
Coral IPx 500 Installation Manual
CLA Car
d
CoraLINK
Adapter
8
5. If DBX card is installed, skip to step 7. Install three type A spacers (see
Figure 8-14
)
provided with the CLA card into the three mounting holes on the MCP-IPx. See
Figure 8-5
.
6.
Remove the three nylon screws threaded into the top of the three standoff spacers
if you have not already done so, and save them for further use. Refer to
Figure 8-5
for the location of the memory interface connector on the MCP-IPx card.
7. If the CLA is to be stacked over another DBX card, install the four spacers (two of
each, types A and B) provided with the CLA, into the two mounting holes (see
Figure 8-14
) on the MCP-IPx to secure the CLA.
8. Carefully align the multi-pin plug on the bottom of the CLA card with the mating
J1 connector on the MCP-IPx card, or on the extension connector of the "lower"
DBX.
9. Gently but firmly press the CLA plug into the MCP-IPx or the DBX connector
until the CLA card rests on the nylon spacers. A slight resistance will be felt as the
connectors engage.
10. Reinsert the nylon screws through the mounting holes of the CLA card and thread
the screws into the nylon spacers until snug.
11. For F-CLA 686 card type, if not already inserted, insert the appropriate CLA
compact flash memory disk (CFD) into the drive on the CFCLA mini module. See
Figure 8-11
.
12. Verify that all slide switches (on the CLA right side) are set to OFF (right).
13. Install the MCP-IPx as described on
page 8-16, MCP-IPx Card Installation
.
Verify that the pins of the CLA plug are aligned with the pin sockets of the MCP-IPx or
the DBX connector.
Do not over-tighten the nylon screws or they may be damaged.