Tadiran Telecom Coral IPx 500, Руководство по установке

Страница: 107 / 544

Hardware Installation Procedure
2-65
Eq
uip
m
ent Insta
lla
tio
n
2
0
This section describes how to interconnect the cages within the Coral IPx 500 system.
For a full description of the different system configurations, see
page 6-49,
Interconnecting the Main and Expansion Cages
.
An H500-1 cable is supplied with the IPx 500X and 800X expansion cages and is used
to connect the backplanes of the cages.
The H500-1 cable has two D-Type 50-pin terminations: a male connector at one end
and a female connector at the other end.
Connecting the H500-1 Cable between the Main Cage and 1st Expansion Cage
1. Plug the male end of the H500-1 cable into the female D-type connector labeled
TO EXPANSION CAGE located in the top section of the main cage.
2.
Plug the female end of the H500-1 cable into the lower connector labeled FROM
CONTROL UNIT OR FIRST EXPANSION UNIT in the top section of the first
expansion cage.
3. Tighten the screws on both sides of the cable to secure it.
Connecting the H500-1 Cable between the 1st Expansion cage and 2nd Exp.cage
1. Plug the male end of the H500-1 cable into the female D-type connector labeled
TO SECOND EXPANSION UNIT located in the top section of the first expansion
cage.
2. Plug the female end of the H500-1 cable into the male D-type connector labeled
FROM CONTROL UNIT OR FIRST EXPANSION UNIT located in the top section
of the second expansion cage.
3. Tighten the screws on both sides of the cable to secure it.
Defining Expansion Cage Numbers
1. Skip to
page 2-66, Setting the Configuration Jumpers
and refer to
Table 2-13
for
cage
number setting jumpers JU2, JU4, JU6 and JU8.
8 Interconnecting the Main and Expansion Cages