Tadano ATF 130G-5, Перевод оригинального руководства по эксплуатации

Страница: 572 / 636

7-9
Other greasing, maintenance and servicing points
2/4
ATF130G-5
2012-11
0305_EN_FA046_7_09_00_00_FA029 ab FZ 031.DOC
- Derrick boom
≥
20°, extend the 2 telescopes
until the lubricating surfaces for booms are
completely accessible laterally and from below
(3). Derrick the boom in horizontal position.
- Grease the sliding surfaces – lateral and below
the boom – as per the maintenance schedule.
- Repeat the process till all the sliding surfaces
have been lubricated.
9.2 Derrick cylinder
The derrick cylinder bearing is lubricated with the help of a central lubricating
system.
Clean the visible area of the piston rod of the elevation cylinder in accordance with the maintenance
schedule and coat it with "Lube Protection Spray" (in transport position).
Reduce these intervals if the mobile crane is operating in aggressive air (e. g. in salty air at the seaside). The
piston rod of the elevation cylinder must be cleaned and coated with "Lube Protection Spray" as required.
9.3 Bottom block
•
Grease the load hook traverse and load hook bearing regularly using the lubricator as per the maintenance
schedule. The greasing intervals depend on the number of operating hours and the conditions of use and
must be executed earlier as specified in the maintenance schedule under extreme conditions if necessary.
WARNING
Welding on the bottom block
A welded bottom block can break. The load can fall because of this. This may
result in accidents.
a)
Welding work on hook blocks is prohibited.
9.4 Counterweight
•
Check the leak tightness of the locking cylinder as per the maintenance schedule. Check the functioning of
the lock and cylinder fastening.
9.5 Jib*)
•
Grease bearings, bushings and boltings.
•
Grease the boltings for attaching the adapter unit to the boom head.
9.6 Central lubricating system
For instructions regarding operation, servicing and maintenance as well as specifications of lubricants and
lubrication points, please refer to the documents provided by the device manufacturer.
The manufacturer's specifications must be observed.