Tadano ATF 130G-5, Перевод оригинального руководства по эксплуатации

Страница: 400 / 636

Correct Incorrect
The rope socket of the customary rope clamp is attached as follows:
Fix the rope end to the bottom block (in case of the odd number of rope falls) or the boom head (in
case of the even number of rope falls) using a rope clamp.
Since the rope clamp (2) is a connection that is safely closed only under a tensile stress, the free
end of the rope must be secured against pulling even in case of a self-inhibiting rope wedge (3).
Observe the following important instructions:
Always insert the hoisting rope such that the pulling rope runs along the pulling axis of the rope
clamp (A).
If the hoisting rope is inserted incorrectly, it will kink, break and wear out early.
The free end of the rope must be secured using a rope clamp (1).
Do not use any devices for securing if they connect the free end of the rope to the carrying rope fall
such that forces can be transferred.
After pinning the rope clamp on the boom head or the bottom block, increase the load gradually
until the rope wedge reaches its end stop.
Hoisting rope reeving examples
Depending on the required lifting load, determine the bottom block and the required number of rope
falls with the help of "Notes regarding the lifting capacity chart" and the lifting capacity charts.
Reeve the hoisting rope depending on the required number of rope falls as described below:
If possible, the reeving in the bottom block should be done such that the bottom block is suspended
vertically especially in case of a small number of ropes (see the 4-line example).
3 Operation
400
ATF 130G-5 2146097
2014-09