Tadano ATF 130G-5, Перевод оригинального руководства по эксплуатации

Страница: 219 / 636

Determine the required boom length exactly before starting work.
Enter the target telescope state in the operator panel of the automatic safe load indicator. Deter‐
mine the desired boom length using the lifting capacity charts and the lifting height diagram.
When telescoping, the boom must be raised at least to 75°.
Do not derrick it during the telescoping operation.
The data for changing the counterweight variants or outrigger variants can be entered only when
the telescope is retracted.
Left crane control lever (4)
Extend from the initial position (2) to the front (1),
Retract from the initial position (2) to the rear (3) - 2.,
The telescoping speed can be controlled depending on the deflection of the crane control lever and
by changing the engine speed.
The telescope extends as per the required setup condition.
Press the Fast-approach switch.
The telescoping speed is also increased until this switch is pressed.
The fast-approach circuit must be activated before actuating the crane control lever.
If a load is attached to the hook, the fast-approach circuit should not be activated.
Telescoping
WARNING
Defect in the length transmitter rope!
The automatic safe load indicator fails. The mobile crane may be over‐
loaded and may overturn. Risk of accident!
1. Further work should not be carried out. Decrease the load. Retract
the boom manually. Rectify the damage immediately.
3 Operation
ATF 130G-5 2146097
2014-09
219