Tadano ATF 130G-5, Перевод оригинального руководства по эксплуатации

Страница: 131 / 636

Code Description Remedy
W0007 Another slewing process will lead to an
overload (or an overload condition has al‐
ready occurred) if outriggers are extended
to different levels towards the left and the
right.
(Slow-stop function for slewing operations
is activated)
Slew in the opposite direction, retract or
lift the telescopic boom.
W0009 Jib LJ is outside the defined offset angle
(falls short of smallest angle).
Lower the jib or raise the telescopic boom.
W0012 Crane does not have adequate stability to‐
wards the back.
Initiate measures for increasing stability
towards the back (e.g. lower the telescop‐
ic boom or extend the telescope).
W0015 Anti-twoblock device is activated when the
anti-twoblock device was overridden at the
same time.
Lower the hook block.
W0016 The lifting capacity of the crane is not in
the defined operating state.
Incorrect combination of counterweight
and outrigger selected.
Save the operating state correctly.
Change the crane state to the correct op‐
erating state.
W0017 The lifting capacity of the crane is not in
the defined operating state.
Incorrect configuration of jib selected.
Save the operating state correctly.
Change the crane state to the correct op‐
erating state.
W0022 Discrepancy between "
HTLJ fully retract‐
ed" switch and HTLJ length sensor.
HTLJ length sensor defective or wrongly
calibrated.
The switch is defective.
Internal AML error.
W0023 Stopped due to overload. Take measures to reduce the load mo‐
ment, e.g. raise the telescopic boom.
W0024 The anti-twoblock device was triggered. Lower the hook block.
W0025 Stopped due to inadequate stability to‐
wards the back.
Initiate measures for increasing stability
towards the back (e.g. lower the telescop‐
ic boom).
▪ If the sensors for the outrigger
length are not installed:
Undefined operating state of lift‐
ing capacity of crane.
▪ Enter correct values for counter‐
weight and outriggers.
▪ If the sensors for the outrigger
length are installed:
right- and left-hand outriggers
are extended to different
lengths.
—
W0026 Upper limit of the telescopic boom angle is
reached (working range limit).
Exit the working range limit function or
lower the telescopic boom.
W0027 Lower limit of the telescopic boom angle is
reached (working range limit).
Exit the working range limit function or
raise the telescopic boom.
W0028 Maximum height of the telescopic boom or
of the jib is reached (working range limit).
Exit the working range limit function or
lower the telescopic boom or retract the
telescope.
3 Operation
ATF 130G-5 2146097
2014-09
131