Tadano ATF 130G-5, Перевод оригинального руководства по эксплуатации, Страница: 132 / 636

Code Description Remedy
W0029 Limit of the working radius is reached
(working range limit).
Exit the working range limit function or
raise the telescopic boom or retract the
telescope.
W0030 Smallest offset angle of the jib LJ or of the
hydraulically adjustable jib is reached.
Lower the jib or raise the boom.
W0034 Rope reserve of hoisting winch 1 is
reached.
Wind hoisting rope of hoisting winch 1.
W0035 Rope reserve of hoisting winch 2 is
reached.
Wind hoisting rope of hoisting winch 2.
W0039 Armrest is folded up. Fold down the armrest.
W0040 Emergency operating mode
(Emergency telescope switch is set to
ON).
The crane must be operated carefully.
See "Emergency operation".
W0041 Incorrect input signal on the counterweight
transmitter.
—
W0042 Right-hand slew limit reached (working
range limit).
Exit the working range limit function or
slew towards the left.
W0043 Left-hand slew limit reached (working
range limit).
Exit the working range limit function or
slew towards the right.
W0045 The telescope cylinder has reached the
end stop when telescoping in the manual
mode.
Retract the telescope cylinder.
W0054 Luffing cylinder has reached the lower end
stop.
Raise the telescopic boom.
W0055 Luffing cylinder has reached the upper
end stop.
Lower the telescopic boom.
W0056 Another slewing process will lead to an
overload (or an overload condition has al‐
ready occurred) if outriggers are extended
to different levels towards the left and the
right.
(Slow-stop function for slewing operations
is deactivated)
Slew in the opposite direction, retract the
telescope or lift the telescopic boom.
W0057 Front-right outrigger is retracted. Extend the front-right outrigger.
W0058 Rear-right outrigger is retracted. Extend the rear-right outrigger.
W0059 Front-left outrigger is retracted. Extend the front-left outrigger.
W0060 Rear-left outrigger is retracted. Extend the rear-left outrigger.
W0061 HTLJ is not pinned. Pin HTLJ with remote control.
W0093 Telescopic boom connecting pin (B-pin) or
telescope cylinder connecting pin (C-pin)
cannot be controlled.
Locking and unlocking sensors for the B-
pin or C-pin are set to "OFF" on both
sides.
Bring the crane control lever back to the
neutral position. Then try again.
When operated, the angle of the telescop‐
ic boom must be > 70°.
When operated with the jib LJ, the angle
of the telescopic boom must be > 75°.
W0094 Telescope cylinder locking bolt (C-pin)
cannot be controlled.
Bring the crane control lever back to the
neutral position. Then try again.
When operated, the angle of the telescop‐
ic boom must be > 70°.
When operated with the jib LJ, the angle
of the telescopic boom must be > 75°.
3 Operation
132
ATF 130G-5 2146097
2014-09