Synectix ATT 2000, Руководство пользователя

Страница: 10 / 56

Programming the Unit
The ATT 2000 Auto Attendant is shipped from the factory with default
settings, which should be good enough to work in most installations.
However, some site-specific parameters may need to be programmed, before
the unit is put into operation.
The following pages list the available programs along with the valid input
parameters and the defaults already programmed in the unit.
The unit has a built in set of voice prompts, which are used to guide the user
during programming and also to ascertain the currently programmed values
in the system.
The unit is fully remote programmable. The user can program and check all of
the values as well as record the DAY / NIGHT / HOLIDAY greeting, from any
remote location, by calling into the unit from a standard touch-tone phone
instrument.
To enter the Programming Mode:
Call in to the ATT 2000 by dialing the extension to which it is connected. The
unit picks up the call and starts playing the DAY / NIGHT / HOLIDAY greeting.
At any time while the greeting is being played, press the `star' key ( Þ ) to enter
the Programming mode.
As soon as
Þ is pressed, the DAY / NIGHT / HOLIDAY greeting stops playing.
Now press another Þ , then the 4 digit password followed by the # key. The
default User password is 6789.
Note: The user password provides access to USER PROGRAMS only, whereas
the Installer Password provides access to ALL PROGRAMS.
If the password is valid, the unit prompts you with the message Enter
Program Number. If the password is invalid, you will hear the message This
entry is invalid and the unit returns to the DAY / NIGHT / HOLIDAY greeting.
Press ÞÞ 6789 # to enter programming mode.
Press ### to exit programming mode.
Note:
In the example given above, the ÞÞ are the password access digits, 6789 is
the password itself and # is the entry terminator. If the caller presses Þ 6789,
it is treated as a transfer to an extension.
10
P
ro
g
ra
m
m
in
g
t
h
e
U
n
it