Symphony C-I-CV43C, Инструкция

Страница: 167 / 174

PR41 - 2 WBPEEUI220772A0
Procedure
□
6. Use the bladed screwdriver to install the four screws that
secure the fan assembly to the weldment.
□
7. Slide the monitor into the rear of the auxiliary terminal.
□
8. Use the ¾-inch open end wrench to install the bolts and
washers on each side of the monitor mounting tray at the rear
of the monitor. These bolts attach the monitor mounting tray to
the auxiliary terminal shelf.
□
9. If the monitor has a touchscreen, connect the touchscreen
cable to the IIMKM02A module.
□
10. Install the power cord and VGA cable to the rear of the
monitor (Fig.
PR41-1 ).
□
11. Verify that the SYNC switch on the rear of the monitor is set
to the VGA position.
□
12. If a touchscreen is installed on the monitor, refer to the
Operation, Conductor VMS and Configuration, Conductor
VMS instructions to perform an on-line calibration of the
touchscreen.
W2
Figure PR41-1. Monitor Connections and Adjustments
T01300A
COMPOSITE
SYNCH
RESISTOR
POSITION
RESISTOR
SWITCHES FOR
75-
TERMINATION
Ω
NO
RESISTOR
POSITION
SCREEN ADJUSTMENTS -
HEIGHT, WIDTH,
BRIGHTNESS, CONTRAST
MONITOR
DEGAUSS POWER
R
REMOTE
AUX 1
VGA VGA
SYNC
GRN CS
REMOTE
SCREEN
CONTROLS
AUX 2
AC
(NOT USED) (NOT USED)
G B CS
DG